-
-
Products
-
-
Blog
Open The Ideal Door To A Clean Area
Installation points of automatic closed door
The basic skeleton material of the automatic closed door is usually a square iron pipe with a thickness of more than 3mm or other building materials with equivalent and better firmness. In the process of installing the automatic closed door skeleton, it is necessary to maintain the vertical level of the overall skeleton and the plane on which the automatic closed door track is installed by tightly kissing it.
2021-11-02
automatic closed doorThe basic skeleton material is usually a square iron pipe with a thickness of more than 3mm or other building materials with equivalent and better firmness. In the process of installing the automatic closed door skeleton, the vertical level of the overall skeleton must be maintained and the plane on which the automatic closed door track is installed must be flat without burrs, for example, if the automatic closed door is installed on the load-bearing wall or other responsible materials, it is necessary to ensure that the aluminum alloy track can maintain horizontal, vertical and firm after installation. At this time, horizontal pipes must be used to measure the level during installation.
Among them, the installation of the anti-swing device of the automatic closed door needs to be installed after the door body is installed, and the ground must be installed firmly, so as to ensure that it does not loosen during long-term use. The sensor of the automatic closed door needs to be highly sensitive and can be installed in places where people often pass by. In some places, it is necessary to prevent the accident of clamping people in the automatic closed door. At this time, some infrared sensors that prevent people from clamping can be installed. The installation of access control system and electric lock is also a necessary auxiliary configuration, and the existence of backup power supply can ensure the normal operation of the automatic closed door after power failure.
electronic inductionautomatic closed doorThe technical content is relatively high, and the reliability of its automation devices, mechanical devices, and intelligent devices is quite different. At this time, the cost of purchase is also very different. In order to ensure that there are fewer failures in the daily use process and more durable And safe, everyone must carefully choose. For the automatic closed door equipped with a guiding lower track, overclocking marking shall be selected during floor construction, and the wooden square shall be accurately embedded in the track position of the automatic closed door. Attention shall be paid to the fact that its length shall be about twice the width of the open door, and the rear shaving groove shall not be adopted. This is to ensure the quality of the notch and look more beautiful at the junction with the ground level and the lower track.
The installation of the upper steel beam of the automatic closed door is an important link in the installation process. The chassis equipped with mechanical devices and electronic control devices is fixed on it. Therefore, the steel beam and the connection between the steel beam and the hole side are required to have certain strength, rigidity and stability. If the design depth in the preliminary construction drawing is insufficient, the design personnel must be contacted and implemented during the construction of the main structure. The embedded parts connected at both ends of the steel beam shall be reliably anchored in the reinforced concrete member. The choice of material is a very important link in the design of automatic door mechanical parts. With the improvement of engineering practice for machinery and parts, as well as the continuous development of materials science,automatic closed doorThe reasonable choice of materials has become an important means to improve the quality of parts and reduce costs.
